Watch as Hannah walks through how to easily install the Single Function Delta® T13/14 Cartridge & Trim in your bathroom tub and shower (model numbers typically begin with T13 & T14). The multichoice universal rough valve from Delta® works with a wide range of styles and finishes. See our supply list and video shortcuts below to make installing even easier.
You’ll Need:
– Phillips head screwdriver
– Hex key
– Adjustable wrench
– Plumbers Tape
– Towel
– Thermometer
Steps:
0:00 Intro
0:59 Valve Install
2:31 Shower Head Install
5:05 Single-Function Valve Tub Spout Install
7:16 Single-Function Valve Trim Install
9:37 Single- Function Valve Adjust Rotational Limit Stop
Installing a different cartridge and trim? Check out our other installation videos:
How to Install the Delta® T17T Cartridge & Trim – https://youtu.be/vP4Dz2isGaM
How to Install the Delta® T17 Cartridge & Trim – https://youtu.be/fmcgyrOfdGo
Thank you really help me a lot 🙏
The faucet I have doesn't have any failsafe for when you're threading it on. The inside of it shifted and it's effed now. No screws inside to hold it in place.
I have a defective spout. I was sent a new one but I'm having a hard time removing the old one. No one is helping me from the new home builder .It's the PIVOTAL®
Monitor 14 Series H2Okinetic Tub and Shower Trim.
Wow…..just wow….Hannah, you did an excellent job on this video! Our house was built just 2 yrs ago and our guest bathroom's Delta tub faucet was dripping quite a bit. This video allowed this gal to repair it herself, and while the water was off, I was able to adjust the severely hot temperature of our master walk-in shower. For 2 yrs it's been super hot even though the handle was mostly towards the C (cold) mark! Thanks so much for the efforts of providing such a helpful and precise training video!
What if the cartridge isn’t turning the water off?
Does your slide on adapter no longer have a set screw? I recieved only one adapter which doesn't have a set screw making me think it's a solder on one.
This video allowed me to complete my project with confidence. Adjusted the hot water and all. Thank you!
Clear, concise and extremely helpful!!! Thanks.
How do u adjust water pressure
this looks like it's for a new home I have a old home with previously installed items
I like how you deliberately don’t put silicone on the bottom of the faucet and then smear it all over the wall, making what she did completely useless 😅
This was a huge help for me. My faucet set didn't come with any direction for the tub spout except for the ones on the bag which did not include anything about the method shown in this video. Glad I looked it up before buying everything needed for soldering
It appears that the trims holes for the screws don’t line up with my old one for this product 😢
How do you switch the water to the shower head?
This was so well done thank you!
I can't get the sleeve off it won't budge at all. I'm trying to change the temperature setting. I'm letting it sit with WD-40
The delta temperature handle I got is meant to turn 180 degrees, but the cartridge only turns 90. How do adapt it?
Pay attention boys, you are going to be replacing this piece of junk a lot! 4 months of use and the hot and cold don't mix right anymore. With some research, it looks like I'm lucky, most people are having leaks within the first 6 months.
You would show the easiest way to put the spout on and not soldering or using a threaded adapter….