Looking to install a patio door but don’t know where to start? This video is for you! In just a few minutes, I’ll show you how to remove an old patio door and replace it with a new one. You don’t need any special tools or skills – just follow these simple steps and you’ll be done in no time! Reliabilt patio door install shown.
🔴 Subscribe for more DIY tips to save a TON of money: http://youtube.com/theexcellentlaborer?sub_confirmation=1
🟡 Check out my Amazon store! 👉 https://www.amazon.com/shop/theexcellentlaborer . Here you will find tools and supplies used in my videos. (DISCLAIMER- I am an Amazon affiliate. I get a small commission that helps support the channel at no extra cost to you)
Spray Foam Insulation https://amzn.to/3wUlwNg
Liquid Nails https://amzn.to/3t3AIp4
Wonder Bar https://amzn.to/3LWKqAf
My Tool Belt Setup https://amzn.to/32kmcyz
Tool Belt https://amzn.to/3E4v1Kc
Hammer https://amzn.to/3E8kldp
Tape Measure https://amzn.to/3J68hNx
Speed Square https://amzn.to/3J0cPoF
Timestamps
Intro 00:00
How to measure for a new door 00:31
Removing door 01:57
Installing new door 05:13
Outro 12:32
Disclaimer: This video is all based on my personal opinion and is for entertainment purposes ONLY. I am not a financial advisor, CPA, attorney, tax advisor, electrician, plumber, housing contractor, designer, or any type of profession to give advice. I am just a consumer sharing my experiences and research. If you do need knowledge for those types of things, I will advise you to seek help for those professionals.
No flashing? Doors gonna a rot.
Why not seal around nail flange with seal tape? The rest looked great.
Why not speed the video up for the whole video, since more then half of if you sped it up. Video was useless
This was extremely helpful… im a new home owner and wanted to replace my sliding doors… i like to see the procedure but ill keep paying you professionals
I like the old door better.
What’s a fair price to have that done?
$360 door? Now that's a cheap door! Great install. I need to tackle this on two doors.
Great job
Fantastic video. You give very precise instructions without any extra chatter. You show each step very clearly and explain the reasons why. You definitely boosted my confidence so that I feel good about trying this myself. You just found yourself a new subscriber.
Loved this video as the French Door you removed is the exact one we want to replace. Question, can you convert this French door (the one you removed) into a single door using the door from the French door you removed?
How much does it cost to install one
Very good information. Thanks
How much it cost to hire people to replace my door patio?
hello Josh. I did the reverse. I removed the sliding doors and I'm adding French doors. I' stuck after removing the sliding doors. How do I remove the aluminum frame that held the sliding doors? Thanks.
the first thing I wish you would do is stop saying, gonna wantna do.
No need for flashing tape on the framing at bottom to prevent water damage?
Would you be able to reuse the door you take out in another opening? I am having French doors installed but would like to reuse my sliding doors they remove for another opening that currently has a sliding door. The sliding doors I want to replace frost up in the winter but the sliding doors that the French doors are replacing don't frost up.
Thank you! 🙂
You didn't build up or shim on the sides?? Especially the lock side because I can see the nailing flange?
So at 11:02 you show how to set the reveal and adjust the latch. From the inside view we can see the holes to the latching side nailing flange are missing the opening.
Did you install the piece of ? quarter ? board to fill that gap then somehow attach to that? Or is the latching side only fastened by two small latch screws?